6.5 Cleaning The Fire & Fuel-Bed / Glass Panel - Flavel Caress HE Installation, Maintenance & User Instructions

6.4 CLEANING THE FIRE - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool. All trims, frets and fascia options supplied with this range of fires must
only be cleaned with a clean, damp cloth.
The trim is best cleaned in position on the fire when the appliance is not running
and is cool. Black painted metal parts should be gently cleaned with a damp cloth.
6.5 CLEANING THE FUEL-BED / GLASS
We do not recommend cleaning of the coals or fuelbed components as these are
fragile and damage may result. None of these parts must be washed or
exposed to any cleaning agents or water. Any damaged parts must be
replaced by contacting your dealer or telephoning BFM Europe Ltd. on the number
stated on the rear cover of this book. The coals must only be replaced with a
complete and genuine replacement set and the fire must never be run with the
wrong number or damaged coals. The fuel-bed must be carefully re-assembled as
stated in section 6.3, pages 47-51.
To clean the glass panel, please remove it from the product as described in pages
10-11. Use a clean damp cloth and ceramic glass cleaner to remove any stains or
deposits frm the glass panel. Do not using scouring pads as this may scratch the
surface finish of the glass panel.
PLEASE NOTE :- The glass will require cleaning periodically. Condensation
produced by the products of combustion will create marks on the inside face of the
glass panel.
6.6 REMOVAL AND RE-FITTING THE TRIMS / FRETS
6.6.1 REMOVAL / REPLACEMENT OF THE CAST IRON FASCIA - ALL
CARESS MODELS
a) The cast iron Caress fascia is fitted to the product by hooking the
4 off retaining brackets (fitted to the fascia during installation) into the
slots in the firebox. See Section 3.6 on page 29 for illustrations.
6.6.2 CARESS TRADITIONAL MODELS - REMOVAL / REPLACEMENT OF
THE FRET
a) The Caress traditional fret can be simply lifted clear of the product.
b) To replace, place fret up to the front radiused burner heat shield, and
place ashpan cover under fret assembly and centralise.
54