Installation Of Fire; Unpacking The Fire; Installing The Fire Box - Flavel Caress HE Installation, Maintenance & User Instructions

2.1

UNPACKING THE FIRE

Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List
1off Fire box / burner assembly
1off Boxed ceramic base, front ceramic rail and 19 coals (4 off "FR"coals 9 off "L" large & 6 off
"S" small coals) - packed inside combustion chamber.
1off Loose items bag including remote handset and 6AA / 1 off 9Vbattery on RC models, flue
restrictor baffle, mounting brackets for cast iron trim / contemporary fret mounting brackets.
1off each Installation & Maintenance / User Instruction Book
1 off each Contemporary or Tradutional Fret & Cast Iron Trim
2.2

INSTALLING THE FIRE BOX

Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys 175mm (7 inch) diameter lined
brick or stone flue, insulated pre-fabricated metal flue box to BS 715 / BS EN
1856-2. When installing into 125mm (5 inch) diameter lined brick or stone flue, or
insulated pre-fabricated metal flue box and liner to BS 715 / BS EN 1856-2 the
restrictor baffle must not be fitted.
The flue restrictor baffle (supplied in the loose items) should only be used in
225 x 225mm (9 inch x 9 inch) brick built chimneys where the flue pull is
excessive. It must not be fitted if installing the product into a metal flue box
or 125mm diameter lined flue. See fig 2b / 2c below for details on fitting /
removing the restrictor baffle onto the spigot on the rear of the firebox.
A spillage test must always be carried out to check satisfactory clearance of
flue products, regardless of the type of flue the appliance is being fitted to.
SECTION 2

INSTALLATION OF FIRE

9
Fig 2b
Baffle Not Fitted
Fig 2c - Flue Restrictor
Baffle Fitted via 3 screws
as shown
3 screws
Flue Restrictor
-