ASSEMBLING FUEL BED AND COMMISSIONING
3.1
ASSEMBLING THE CERAMICS AND FUEL BED
a)
Place the insulation mat centrally on to the fuelbed support then place
the ribbed hard ceramic fuelbed base on top of the mat and pull both
fully forwards to the burner. Make sure that the fuelbed base is
located centrally in the fire box. Ensure that both the mat and
fuelbed base fit fully down onto the fuel bed support and are not
lodged on the burner. See fig. 10 & 11 below.
Fig. 10
Fig. 11
Supplied By www.heating spares.co Tel. 0161 620 6677
SECTION 3
Side view showing fuelbed incorrectly
positioned on burner skin
Side view showing fuelbed correctly located
behind burner
17