Introduction - Baxi Solo 3 Installation And Servicing Instructions

Users Operating Label
Fig. 1
British Gas Service
Test Point.
For use by B.G.
Personnel only
Combustion Box Door
Data Badge
Fig. 2
IMPORTANT:
STATEMENT OF ADJUSTMENT. Check that the state of adjustment
given on the data plate is compatible with local supply conditions
"Benchmark" Log Book
As part of the industry-wide "Benchmark" intiative all Baxi boilers now
include an Installation, Commissioning and Service Record Log Book.
Please read the Log Book carefully and complete all sections relevant to
the appliance and installation. These include sections on the type of
controls employed, flushing the system, burner operating pressure etc.
The details of the Log Book will be required in the event of any warranty
work. Also, there is a section to be completed at each subsequent regular
service visit. The Log Book must be left with the user.
4
Supplied By www.heating spares.co Tel. 0161 620 6677

1.0 Introduction

1.1 Description
1. The Baxi Solo 3 PFL System is a gas fired room
sealed fan assisted central heating system boiler
with outputs as shown in the table below.
Model Heat Output
30
8.79kW (30,000 Btu/h)
40
11.72kW (40,000 Btu/h)
50
14.65kW (50,000 Btu/h)
60
17.58kW (60,000 Btu/h)
70
20.5kW (70,000 Btu/h)
80 23.44kW (80,000 Btu/h)
2. Each appliance is preset at a heat input rating
and is designed for use on NATURAL GAS only.
3. All boilers are suitable for sealed fully pumped
systems only.
4. The appliance incorporates a circulating pump
and expansion vessel.
5. The appliance data badge is fitted to the
combustion box door, an abbreviated version is on
the inside of the front panel.
6. All illustrations show the Solo 3 PFL System 50
boiler.
1.2 Installation
1. The appliance is suitable for installation only in
G.B. and I.E. and should be installed in
accordance with the rules in force. For Ireland
install in accordance with I.S.813 "I
G A ". The installation must be carried
AS PPLIANCES
out by a CORGI Registered Installer or other
competent person and be in accordance with the
relevant requirements of the current G
(Installation and Use) R
EGULATIONS
R (Scotland) (Consolidation), the L
EGULATIONS
B R , the C
UILDING EGULATIONS URRENT
R and the bye laws of the Local Water
EGULATIONS
Undertaking. Where no specific instructions are
given, reference should be made to the relevant
BRITISH STANDARD CODES OF PRACTICE.
2. All systems must be thoroughly flushed and
treated with inhibitor (see Section 4.2).
1.3 Important Information
Man-Made Mineral Fibre
a) Some component parts of this appliance
(insulation pads, gaskets and rope seals) are
manufactured from man-made mineral fibre.
b) Prolonged or excessive exposure to this
material may result in some irritation to the eyes,
skin or respiratory tract.
c) It is advisable to wear gloves when handling
these items.
d) Irritant dust will only be released from the items
if they are broken up or subjected to severe
abrasion. In these instances a suitable dust mask
and goggles should be worn.
e) Always thoroughly wash hands after installation,
servicing or changing components.
f) When disposing of any items manufactured from
man-made mineral fibre care must be exercised.
g) If any irritation of the eyes or severe irritation of
the skin is experienced seek medical attention.
NSTALLATION OF
S
AS AFETY
, the B
UILDING
OCAL
I.E.E. W
IRING
1