Information Before Installing; General Delivery Terms And Conditions; Content; Technical Specifications - Zodiac PW 5M-7M-9M-11M Instructions For Installation And Use Manual

1. Information before installing

1.1 General delivery terms and conditions

All equipment, even postage and packing paid, travels at the risks and perils of the recipient. The latter must make
written reserves on the transporter's delivery documents if damage during transport is discovered (confirmed by
registered letter to the transporter within 48 hours).
If the appliance has been tipped over, make written reserves to the transporter.

1.2 Content

PW
x1

1.3 Technical specifications

PW
Single phased voltage
Input power*
Rated input intensity*
* with surrounding air temperature at 15°C and pool water at 24°C, humidity level 70%
• Operating temperatures: from 7 to 32°C air and up to 32°C water (30°C with Zodiac® Easy Connect)

2. Installation

Do not lift the appliance using the casing, handle it from the base.

2.1 Selection of the location

The appliance must be installed outside and be surrounded by free space (see §2.3).
• the heat pump must be installed at a minimum distance from the edge of the pool in order to avoid any projections
of spray onto the appliance. This distance is determined by the electric standards applicable locally (for France: 3.5
meters).
• the heat pump must not be installed:
-
close to a heat source or to a source of inflammable gas,
-
close to a road with a risk of water or mud being sprayed,
-
facing strong winds,
-
with the blower facing a permanent or temporary obstruction (window, wall, hedge, etc.) less than 3 metres away.

2.2 Installing the appliance

• install on a stable, solid surface (concrete slab for example) which is level,
• protect from risks of flooding due to condensates from the appliance when it is
running.
The anti-vibration pads are built into the heat pump base.
The appliance can be fixed to the ground using the holes in the appliance
base, or using rails (not supplied). It is also possible to fix the appliance to
brackets (not supplied).
A drilling diagram is available on the back of the packaging box.
3
Screw-on
Wintering Cap
fitting
x2 x2
kW
A
Gasket Ø40 Adapter
x2
5M 7M
230V-50Hz
0.98 1.56
4.45 7.09
Ø50 Adapter
x2 x2
9M
2
9.09
Fixing holes
H0357900.D - EN - 2014-03
11M
2.6
11.82