Internal Connectors; Power Connector (Atx24P); Power Connector (Atx4P) - Kontron KTH81/mITX User Manual

KTD-N0882-I
7

Internal Connectors

The KTQ87/KTH81 boards are designed to be supplied from a standard ATX (or BTX) power supply. Use of
BTX supply is not required for operation, but may be required to drive high-power PCIe cards.
Warning: Hot plugging any of the two power connectors is not allowed. Hot plugging might damage the
board. In other words, turn off main supply etc. to makesure all the power lines (+12V, 5V, SB5V, 3.3V, -5V,
-12V) are turned off when connecting to the motherboard.
Note 1: Use of both the ATX24P and the ATX4p connectors are required for operation of the KTQ87/KTH81.

Power Connector (ATX24P)

7.1
Note Type Signal
PWR 3V3
PWR +12V
PWR +12V
PWR SB5V
I P_OK
PWR GND
PWR 5V
PWR GND
PWR 5V
PWR GND
PWR 3V3
PWR 3V3
See chapter "Power Consumption" regarding input tolerances on 3.3V, 5V, SB5V, +12 and -12V (also refer
to ATX specification version 2.2).
Signal Description
P_OK is power good signal driven by the ATX Power Supply and indicating that the +5VDC and
P_OK
+3.3VDC outputs are above the undervoltage thresholds.
The recommended electrical and timing characteristics of the P_OK (PWR_OK) signal are
provided in the ATX12V Power SupplyDesign Guide.
It is strongly recommended to use an ATX or BTX supply, in order to provide supervision of the 5V
and 3V3 supplies. These supplies are not supervised on-board.
PS_ON# Active low open drain signal from the board to the power supply to turn on the power supply
outputs. Signal must be pulled high by the power supply.

Power Connector (ATX4p)

7.2
Note Type Signal
PWR GND
PWR GND
Page 39
PIN Signal Type
12 24 GND PWR
11 23 5V PWR
10 22 5V PWR
9 21 5V PWR
8 20 -5V PWR
7 19 GND PWR
6 18 GND PWR
5 17 GND PWR
4 16 PSON# OC
3 15 GND PWR
2 14 -12V PWR
1 13 3V3 PWR
PIN Signal Type
2 4 +12V PWR
1 3 +12V PWR
KTQ87/KTH81 Users Guide
Internal Connectors
Note
1
Note
1
1