7/ Internal Connectors
7.1. Power Connector
Power connector must be used to supply the board with +12 VDC (±10%).
Hot plugging any of the power connector is not allowed.
Hot plugging might damage the board. In other words, turn off main supply etc. to make
sure all the power lines are turned off when connecting to the motherboard.
7.1.1. Power Input Wafer (CN2)
Figure 11: Power Input Wafer CN2
Table 17: Pin Assignment CN2
Pin
Signal
1
+12V
2
GND
3
GND
4
+5V
7.1.2. RTC Power Input Wafer (BAT1)
Figure 12: RTC Power Input Wafer BAT1
Table 18: Pin Assignment BAT1
Pin
Signal
1
+VBAT
2
GND
www.kontron.com
Description
Power +12 V
Ground
Ground
Power +5 V
Description
Battery supply for RTC
Ground
ECX-KBL-U - User Guide, Rev. 1.0
// 33