Usb Power Select; Internal Peripheral Device Connections; Sata Drive Connection; Figure 4-7: Msata/Sata Switch Location - IEI Technology KINO-DBT Series User Manual

KINO-DBT Mini-ITX SBC

Figure 4-7: mSATA/SATA Switch Location

4.3.5 USB Power Select

The USB power selection is made through the BIOS options in "Chipset
BIOS menu. Use the USB SW1 and the USB SW2 BIOS options to configure the power
source to the corresponding USB ports (see Table 4-3).
BIOS Options
USB SW1
USB SW2

Table 4-3: BIOS Options and Configured USB Ports

Please refer to Section 5.4.2 for detailed information.

4.4 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the on-board connectors.

4.4.1 SATA Drive Connection

The KINO-DBT is shipped with one SATA drive cable. To connect the SATA drive to the
connector, please follow the steps below.
Step 1: Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Configured USB Ports
LAN1_USB1 (external USB 3.0 ports)
LAN2_USB2 (external USB 2.0 ports)
USB1, USB2 (internal USB 2.0 ports)
South Bridge"
Page 59