Cover Sub-Assembly - JLG 3369LE Service Maintenance Manual

Cover Sub-Assembly

1. O-Ring
2. Cover
3. Thrust Washer
1. Grease O-Ring (7) and insert groove in Cover (2).
2. Assemble Disengage Cap (5) onto Cover using two
Hex Head Bolts (4). Torque bolts to 70-80 in-lbs.
3. Insert Disengage Rod (6) into hole in Cover until it
touches the inside of the Disengage Cap.
NOTE: The Disengage Rod can be inserted either end first.
3121122
4. Hex Head Bolts
5. Disengage Cap
6. Disengage Rod
Figure 3-25. Cover Sub-Assembly
4. Grease the face of the Thrust Washer (3) and place
5. Install the O-ring Pipe Plugs (8) into the Cover. The
– JLG Lift –
SECTION 3 - CHASSIS & SCISSOR ARMS
7. O-ring
8. O-ring Pipe Plugs
in the Cover making sure the tangs on the Washer
seat into the pockets in the Cover.
plugs should be hand tight according to SAE stan-
dard.
3-41