SECTION 3 - CHASSIS & TURNTABLE
Cover Sub-Assembly
1.
Using disconnect rod, push O-ring (6F) into groove
inside cover cap (6B).
2.
Place O-ring (6G) onto cover cap (6B) so it rests against
flange of cover cap.
3.
Insert disconnect rod (6E) into cover cap (6B).
3-18
4.
Set cover (6A) on table, exterior side up. Place cover cap
(6B) on cover (6A). Align pipe plug hole in cover cap over
pipe plug hole in cover.
5.
Place two cover cap bolts (6C) in any two bolt holes 180°
apart on cover cap (6B) and tighten bolts.
6.
Using a torque wrench, apply 36 to 49 in. lbs. (4 to 5 Nm) of
torque to both bolts (6C).
31215022