5.1 HAND HELD ANALYZER
Analyzer Display
Escape Key
To return home or access
previous menu
Up & Down Arrow Keys
Value Selector
To Connect the Hand Held Analyzer:
1. Connect the four pin end of the cable supplied with
the analyzer, to the four position connector on the
PCB and connect the remaining end of the cable to
the analyzer.
NOTE: The cable has a four pin connector at each end of
the cable; the cable cannot be connected back-
wards.
3121122
SECTION 5. JLG CONTROL SYSTEM
m en u:
HELP:
PRESS ENTER
Figure 5-1. Hand Held Analyzer
– JLG Lift –
SECTION 5 - JLG CONTROL SYSTEM
Stores and selects Top Level, Sub
Left & Right Arrow Keys
Used to move between Top Level,
Sub Level, and item menus
2. Power up the Control System by turning the lower
key to the platform position and pulling both emer-
gency stop buttons on.
Enter Key
Level, and item menus
5-1