Connection Testing - Santec SDVR-1/TX-S User Manual

5.1.4 Connection Testing

With the previous settings, follow the
instructions below to ensure whether you
have established
successfully.
1.
Click Start  Command Programs
2.
Type in ping 192.168.1.1 then Enter.
(See the sample screen below)
** This IP is the DVR IP address that is
assigned for the connected DVR.
3.
If you receive a response as in the
sample screen below, the connection
hasn't been successfully established.
Please re-check all the hardware and
software installation by repeating steps 1
to 5. If you still can't establish the
connection after
the connection
rechecking, please
45
contact your dealer.
4.
If you receive a response as in the sample
screen below, you have successfully made
the connection.