Santec SDVR-1/TX-S User Manual page 6

PAUSE button:
3
In a playback display, press this to freeze the display. During the freeze, press to display one
frame/field of a picture at a time in the forward direction. (A green light is on the PAUSE mode.)
PLAY button:
4
Press to play back a recorded video from the hard disk. (A green light shows in the PLAY mode.)
STOP button:
5
Press to stop playing back a recorded video. (A green light goes on in the STOP mode.)
REC button:
6
Push to start recording video into a hard disk while in the live display mode. (A red light turns on
in the REC mode.)
POWER button:
7
Press this button for at least 3 seconds to power off. Press again to activate the device.
DISPLAY button:
8
Press to show the system operation status on the screen.
Setup button:
9
Press this to enter the setup menu. Press again to exit the setup mode.
Search button:
10
Press to enter the search mode to access the recorded video.
Left / Right buttons:
11 14
Press the two buttons to highlight desired items in the menu setup mode. For Key Lock operation,
press these two buttons simultaneously once; to disable Key Lock, press these two buttons
again simultaneously.
Up / Down buttons:
12 13
Press these two buttons to select the desired contents for programming in the setup menu mode.
Enter Button:
15
Press to enter a selected item and save the setting in the menu setup mode.
Monitor button:
16
Press to switch between a multiplexer-decoded video and the encoded video to be displayed
when connected with a multiplexer. When the button light is on it indicates the unit is displaying
the decoded video.( The images are not multiplexing . ) In this mode, the unit doesn't display the
OSD message of the unit on the screen. However, this doesn't affect the unit's OSD message,
which is recorded into hard-disk drives. When the button light is off it indicates the unit is
displaying encoded video. (The images switch swiftly).
T-rec Indicator:
17
This indicator of the timer recording mode lights up to signal the scheduled record setting is on.
A-rec Indicator:
18
This indicator of the alarm-recording mode lights up to indicate the alarm record setting is on.
DISK Indicator:
19
The indicator shows the operation status of the unit's hard-disk drives. The green light indicates
the hard-disk drive is storing or retrieving data. The red light signals the hard-disk drive is filling up.
The orange light indicates the hard-disk is retrieving a disk-full status.
6