Santec SDVR-1/TX-S User Manual page 39

PASSWORD:
This option allows you to set a password to
prevent any unauthorized re-formatting of the
hard disk drives or use by a network viewer.
The standard password is "9999".
OLD PASSWORD:
password
password if this is the initial setting)
to access the password setting
system.
NEW PASSWORD: Enter a 4-digit-number
password of your choosing which
will replace the pre-set password
(or the standard password "9999").
SETUP PWD:
When this option is on, the user must pass the
password check before entering the setup
menu.
ON: Enables pass protection for the setup
menu.
OFF: Disables pass protection for the setup
menu.
DEFAULT:
This option allows you to reload the factory
default setting. Please do note that the
password would not be changed in the factory
default setting.
SD SETUP:
The DVR offers a quick setup method by using
an SD card. If the user wants to set up a lot of
the same devices with the same settings, he
can save the whole settings to an SD card, then
transfer them to another DVR.
SAVE: Saves the whole setting to the SD
card.
LOAD: Loads the whole setting from the SD
card.
Enter the pre-set
(or the standard
39
VERSION:
This item is in the setup menu revealing the
network MAC, the BIOS version, software
version, and the last updated date.
MAC : 00:0C:0C:00:B1:30
BIOS : 1.00
SW : 1.12
DATE : May 29 2006