Cleaning The Glass Panel - SCAN DSA 5 Instructions For Installation And Use Manual

Cleaning the glass panel

The door must be dismounted from the stove before installing a new glass.
When firing with moist wood, during the first lighting, or by a small fire/heat requirement, a bad
combustion may arise, which can cause that the glass gets more or less sooty. The glass is easily and
effectively cleaned when using a commercial glass cleaner designed for stoves (available at your
dealer) do not use abrasive cleaners. The doors is opened as follows:
1. In order to protect the ceramic gasket in the bottom of the door, you should place the delivered
distance tool (1, fig. 5) under the column on the left side of the door.
2. IMPORTANT! Close the door and LOCK it. The door is locked by means of the locking button
(2, fig. 6) on the right side. The locking button is to be turned until it clicks. IT IS NOT TO BE
UNLOCKED WHILE WORKING WITH THE DOOR.
3. Turn the screw (3, fig.6) in the middle of the doorframe on the right side clockwise with a 6 mm
hexagon spanner.
4. Swing out the door (fig.7)
5. Clean the glass; this should only be done on a cold stove.
6. Close the door and tighten the screw counter-clockwise. Unlock the door and remove the
distance tool.
NOTE: The lock/lock-pin should not be activated during normal use, as it will then be needlessly worn
and scratch the steering axis.
Be careful not to abuse the glass by striking or slamming the door shut.
Do not operate the stove with broken glass. If the glass breaks, then replace it promptly with original
factory replacement ceramic glass.
Fig. 5
1
Fig. 6
2
Fig. 7
3
18