Page 1
Scan Andersen 4-5 Scan Andersen 4-5 S - Installation and Operating Instructions Scan Andersen 4 - 5 S BP Scan Andersen 4 - 5 BP (Soapstone model) (Convection model) The manuals which are enclosed with the product must be kept throughout the product’s entire service life.
English In case of chimney fi re: 3.0 Safety • Close all hatches and vents. NB! We recommend that installation be carried out by a • Keep the fi rebox door closed. qualified installer, to ensure that the product delivers maximum •...
Page 8
English 4.3 Chimneys and fl ue pipes 4.5 Fitting the convection panels • The fi replace can be connected to a chimney and fl ue pipe approved for solid fuel fi red appliances with fl ue gas Fig. 3 temperatures specifi ed in «2.0 Technical data”. •...
Page 9
English 4.6 Fitting the soapstone panels 4.7 Smoke outlet The product has been prepared for a top outlet by the Fig. 4 manufacturer. Fitting a smoke outlet with a top outlet Fig. 5 1. Place the provided gasket (fi g 5A) to the smoke outlet. There are two loose smoke outlets with the stove Ø125mm and Ø130mm.
Page 10
English Fig. 7 Fig. 10 1. Lift the exhaust defl ector (fi g. 7A) up carefully. 2. Remove the pins (fi g. 7B). 1. Remove the cast iron cover (fi g. 10A) from inside the burn 3. Ease the exhaust defl ector out. chamber.
Page 11
fi nd in the service bag. The vertical position of the handle can be adjusted by turning the set screw on the locking device. Conversion to Scan Andersen 4-5 / 4-5 S Fig. 13 Open 1. Secure the ash lip in place (fi g. 12A) using the screws provided (fi...
The logs should be dried so that the moisture content is no more than 20%. 1. Cut off the lower part of the Scan Andersen 4 - 5 label. To achieve this, the logs should be cut no later than in late 2.
Page 13
English 5.2 Lighting the fi re Adding fi rewood • Stoke the stove frequently but only add small amounts of Wood consumption: fuel at a time. If the stove is fi lled too full, the heat created Kindling (fi nely split wood): may cause extreme stress in the chimney.
English 6.0 Service 6.2 Replacing the burn plates/inner bottom Warning! Any unauthorised changes to the product is not allowed! Only original spare parts may be used! Fig. 19 6.1 Replacing the baffl e/defl ectors Fig. 17 1. Take out the baffl e/exhaust defl ector (see 6.1 - Replacing the baffl...
Any gaskets showing signs of wear or deformation must be replaced. Thoroughly clean the gasket grooves, apply ceramic glue (available from your local Scan dealer) and press the gasket well into place. The joint will dry quickly. 7.5 Exterior maintenance Painted products may change colour after they have been used for several years.
Jøtul AS also guarantees that steel plate parts are free from defects in Scan Andersen 4-5 S BP (Soapstone model) - materials or manufacturing at the time of purchase for a period Top smoke outlet of 5 years from the date of delivery.
English Pellets stoves, glass, stone, concrete, enamel and paint fi nish (e.g. but not limited to chipping, cracking, bubbling or discolouration and crazing) are applicable to the national legislation governing the sale of consumer goods. This guarantee is valid for purchases made within the territory of the European Economic Area.