Table of Contents
Advertisement
To Connect the DC Grounding Cable
Refer to "DC Supply and Ground Conductor Requirements" on page 13 for the site
requirements for this section.
1. Get a DC grounding cable and two M5 nuts with lock washers.
2. Go to the back of the chassis and locate the two DC grounding studs.
Connecting the DC Grounding Cable to the DC Grounding Studs
FIGURE 3-10
3. Remove the plastic shielding from the DC grounding studs.
4. Position and align the DC grounding cable against the two DC grounding studs at
the rear of the chassis.
5. Place the star washers between the DC grounding cable and the two nuts that you
will use to secure one end of the grounding cable to the two studs.
6. Tighten the two nuts to secure the grounding cable to the two studs.
Chapter 3
Mounting the Chassis in a Rack
29
Advertisement
Table of Contents
