Removing The Driven Pulley; Inspecting The Clutch Drum; Removing The Clutch - Derbi GP1 50 cc Workshop Manual

R R
EMOVING THE DRIVEN PULLEY EMOVING THE DRIVEN PULLEY
- Lock the clutch bell housing with the specific tool.
- Remove the nut, the clutch bell housing and the whole of
the driven pulley assembly.
N.B.
THE ASSEMBLY CAN ALSO BE REMOVED WITH THE DRIVE
PULLEY IN PLACE.
Specific tooling
020565Y Compass flywheel stop spanner
I I
NSPECTING THE CLUTCH DRUM NSPECTING THE CLUTCH DRUM
- To verify that the bell clutch is not usurata or damaged.
- To measure the inner diameter of the bell clutch.
Characteristic
Clutch bell diameter/standard value
0107+0,2 +0 mm
Clutch bell diameter/max, value allowed after use
0 107,5 mm
Found eccentricity /max.
0,20 mm
R R
EMOVING THE CLUTCH EMOVING THE CLUTCH
- Fit the tool with the long pins screwed on from the outside
in positions «A». Insert the driven pulley assembly into the
tool and tighten the central screw.
CAUTION
OVERTIGHTENING OF THE CENTRAL SCREW CAUSES THE
DISTORTION OF THE TOOL.
45