Wellav UMH160R User Manual page 42


Alarms setup
In this section, you can set the alarm information to monitor the device and signal. After
setting the "Alarm Mask" on, the "GPI" item will be optional. If you set the GPI on, when
there are LNB Disconnect, Signal unlocked, CAM error, decoder failure, ASI output lost error,
the alarm information will be sent out via GPI.

User Management
 Change Password:
When choose this button, you are able to change the password with a new one.
But you should enter the old password firstly.
 Change Username:
PIC-3.4-35
PIC-3.4-36
41