Wellav UMH160R User Manual page 33

This page shows the local IP setup and Input IP information. There are two channels
available to receive IP streams. Before you can receive the IP streams, you should configure
the following parameters:

IPAddress: Local IP setting for connecting to the server. This IP and the
management server's IP should be in the same section.

SubnetMask: Network Mask setting for connecting to the server. It should be
the same as management server: 255.255.255.0

GateWay: Gateway setting for connecting to the server. It should be the same
as the management server.
The parameter of channel 1 and channel 2:

Enable: Enable or disable corresponding output channel

Source IP Address: it is the IP address of the source IP streams.

Source Port: It is the port of source IP streams.

Protocol: You can choose UDP or RTP for multicast/unicast.
3.4.2.7 Outputs( For UMH 160R-BASE/ UMH 160R-L/ UMH 160R-SDI)

Program Setup
In this interface, user can view and configure the decoding output program parameters,
including: Program, CAM, Video, Audio, Subtitle and Subtitle.
32