Wellav UMH160R User Manual page 24

3.4.2.2 Status Page (
This page shows the current operation status of the equipment. Therefore, you can monitor
and check the following:

General Status: if the signal locked, it shows the signal status in green, otherwise,
it shows in red.

RF Status: here, you can monitor the main information of RF signal, such as RF
level, frequency tune, frequency offset, FEC.

Stream Information: it shows the information of transport stream rate, transport
stream ID, original network ID and stream time.

TS Status: here, you can monitor the TS rate, TS effective rate to ensure the
device is under normal status.

Program Information: here is the information of the program that you selected for
output. If the output program is changed, this information will upgrade automatically.

Unit Versions: you can check the version of the hardware and software here.

CI Status: if the CI card is plugged in, it will show here.
Press the "Refresh" button to refresh the interface.
For UMH160R-BASE/UMH 160R-L/ UMH 160R-SDI )
PIC-3.4-7
23