Wellav UMH160R User Manual page 31

to receive satellite signal with different polarization. Generally 18V is for
Horizontal while 13V is for Vertical.
 LNB 22 KHz: Generally this is used to control 22KHz switch, typically used for
LNB with double L.O. in Ku band. "ON" is for high L.O and "OFF" is for low
L.O.
 LNB LO. Type: this is the type of LNB, including Ku band, C band, universal
and wide band, which also can be obtained from the LNB provider. It usually
stays the same with Frequency Range.
 LNB LO. Frequency: this is the LNB's local oscillation (LO) frequency, every
LNB have one or two oscillation frequencies which can be obtained from the
LNB provider, or you can check on the LNB label. The value is between 5000
and 6000.
Sometimes the parameters may change; it is advisable to check through
www.lyngsat.com
3.4.2.6 Inputs ( For UMH 160R-AD)

DVB-S/S2
Additionally, in this section, you are able to set the dual RF receiver parameters including
the Satellite Frequency, Symbol Rate, LNB Frequency, and LNB Voltage (Polarization) with
accurate values. Then you can press the "Submit" button to save your settings or click
"Refresh" button to refresh the screen.
 SATELLITE FREQUENCY (MHz): this is the satellite down conversion
frequency, every transponder has one frequency, and you can get this
for the updated satellite parameters.
PIC-3.4-19
30