Fuses; Storage Compartment/Tools - Arctic Cat 700 PS EFT Operator's Manual


NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
! WARNING
Do not attempt to remove the bulb when
it is hot. Severe injury may result.
To replace the headlight bulb, use the fol-
lowing procedure.
1. Remove the rubber boot from the
back of the headlight housing; then
remove the three-wire connector
from the bulb.
2. Release the two ends of the spring clip
from the headlight housing making
sure not to bend or deform the clip;
then remove the bulb from the housing.
3. Install the new bulb into the hous-
ing; then secure with the spring clip.
4. Connect the three-wire connector to
the bulb; then install the rubber boot.
CAUTION
When replacing the headlight bulb, be
careful not to touch the glass portion
of the bulb. Grasp the new bulb with a
clean cloth.
To replace the license plate bulb, use the
following procedure.
1. Remove the two screws and remove
the lens.
2. Pull out the bulb.
3. Install the new bulb by pushing it in.
4. Install the lens. Tighten the two
screws securely.
To replace the turn signal light - rear/tail-
light/brakelight bulb, use the following
procedure.
1. Rotate the socket counterclockwise
and remove it from the housing.
2. To remove the bulb from the socket,
push in and rotate counterclockwise.
3. To install the bulb, push in and turn
clockwise.
4. Insert the socket into the housing
and rotate it clockwise.
To replace the front turn signal light/front
position light bulb, use the following pro-
cedure.
1. Rotate the socket counterclockwise
and remove it from the housing.
2. To remove the bulb from the socket,
pull it straight out of the socket.
3. To install the bulb, push it straight
into the socket.
4. Insert the socket into the housing
and rotate it clockwise.

Fuses

The fuses are located in a power distribu-
tion module under the seat. If there is any
type of electrical system failure, always
check the fuses first.

NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift off;
then remove and replace the fuse.
Power Steering
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If the
new fuse blows after a short period of
use, consult an authorized Arctic Cat
ATV dealer immediately.
Storage Compartment/
Tools
A basic tool kit is provided with the ATV.
Maintain the tool kit with the ATV at all
times. The tool kit is located under the
seat.
The storage compartment is above the
engine in front of the seat.
2411-213
55