Electric Fuel Pump - Arctic Cat 700 PS EFT Operator's Manual


NOTE: The Mode Button must be
pressed and released to shift modes.
Approximately two seconds after the
Mode Button is released, the digital
gauge will return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and
resets various displays on the digital
gauge. Also used to shift from
speedometer function to tachometer
function on the
tachometer gauge.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Low Oil Pressure - Will be displayed
during self-test at start-up. It will not
be displayed during normal opera-
tion as oil pressure is not monitored
on these models.
7. Odometer/Trip Meter - Odometer
registers the total distance the vehi-
cle has traveled. The trip meter can
be reset and can be used to measure
trip or trip legs. The odometer can-
not be reset.

NOTE: To shift between
odometer (ODO) or
(TRIP), press the Mode Button (3) to
select the distance mode; then
press the Set/Reset Button (4) to
select the desired display. Hold the
Set/Reset Button down to reset the
trip meter.
8. Gear Position Indicator - Indicates
which gearshift position is selected.
• R (reverse)/N (neutral)/L (low range)/H
(high range)

NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
9. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
10. Differential Lock Indicator - Dis-
plays LOCK when the differential
lock has been engaged.
40
11. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the differential
lock is engaged. The display is blank
when in 2WD.
12. Speedometer - Indicates the approxi-
mate vehicle speed in miles per hour
(MPH) or kilometers per hour (km/h).

NOTE: To change MPH/km/h dis-
play, press and release Mode But-
speedometer/
ton (3) until the icon (MPH/km/h)
appears; then press the Set/Reset
Button (4) to change the display.
13. Right Turn Signal - Will be displayed
when the right turn signal is selected.
14. Left Turn Signal - Will be displayed
when the left turn signal is selected.
Condition Warning Display - Uses odome-
ter/trip meter display of the LCD to warn of
a system error condition requiring attention.
A. Volt - The LCD will go blank
except the word VOLT will flash
on the LCD whenever a low
voltage (< 9 DC volts) or a high
voltage (> 16 DC volts) is
detected. When voltage returns
to normal, the gauge must be
reset by turning the ignition key
to the OFF position and then to
the ON position.
the
B. EFI - The LCD will go blank
trip meter
except the letters EFI will flash
on the LCD whenever an elec-
tronic fuel injection error is
detected. After 30 seconds, the
LCD will return to normal; how-
ever, the letters EFI will continue
to flash until the cause of the
error is corrected.

NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the EFI error corrected and to have
the ECU reset as soon as possible.

Electric Fuel Pump

An electric fuel pump is incorporated in the
gas tank to deliver gasoline to the fuel injec-
tor. The fuel pump is activated when the
ignition switch is in the ON position.