Lcd (Digital) - Arctic Cat 700 PS EFT Operator's Manual


NOTE: Turn the key switch to the
OFF position then back to the ON
position to reset the malfunction
code. If the code continues to be
displayed, take your ATV to an
authorized Arctic Cat Dealer for
EPS system servicing
resuming operation.
CAUTION
Never operate this ATV with a "P0635"
code indicated on the LCD gauge/
speedometer. This indicates a mal-
function in the EPS system control cir-
cuit and could result in a loss of power
steering assist.
In the event of electrical power failure,
the EPS system becomes disabled (simi-
lar to an automobile with the engine shut
off). Steering effort increases but steering
control can be maintained.

LCD (Digital)


NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set
the clock, use the following proce-
dure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed;
then (if necessary) press and
release the Set/Reset Button (4)
to select the clock display.
B. Press and hold the Set/Reset Button
(4) until the minutes stop scrolling
and the hour display starts to scroll.
Momentarily release when the cor-
rect hour is displayed; then repeat-
edly press and release the Set/Reset
before
Button (4) until the correct minutes
are displayed.

NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event
of clock memory power failure
(blown fuse, etc.), the gauge will
"power-up," reset, and shut down
repeatedly
power is restored. Always check the
15-amp accessory fuse if
gauge condition is noted.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the
LCD will go blank for 30 seconds;
then the LCD will return to normal.
However, the temperature icon will
continue to flash.
CAUTION
Continued operation with high engine
temperature may result in engine dam-
age or premature wear.

NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
ACE-015B
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmission
gear can lower the temperature.

NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a
hose, pressure-wash the radiator
and the engine to remove any
debris restricting air flow.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer, distance, and
time.
until clock memory
this
Decreasing
39