Adjusting the Left Margin
You can print a single line of text to help in setting the left margin
position using the Left Margin Alignment Test. You can also change
the current left margin position using this test.
You can set the left margin position from 1 to 66 units (where each
unit is 0.686 mm [0.027 in.]). The factory default setting is 10. The
margin is measured starting at 1.27 mm (0.05 in.) from the center of
|
the tractor pins for continuous forms and the left edge of a cut form.
To align the left margin position, follow these steps:
1. If the printer is ready, press Stop.
The printer displays
NOT READY
2. Enter the Operator Print Tests by pressing Test.
The printer displays
OPERATOR PRINT TESTS
Printer Demonstration
3. Press Scroll
or Scroll
OPERATOR PRINT TESTS
Left Margin Alignment
4. Press Enter or Start to begin the test.
The printer displays
Left Margin Position
xxx
where xxx is the current value of the left margin position.
<A>
until the printer displays
Chapter 1. Setting Up the 4230 Printer
1-75