Compatibility Option 8: Automatic Ff After Operator-Initiated Copy; Compatibility Option 9: Cr, Em, And Nl (3287 Only); Compatibility Option 10: Bottom Margin (Scs Data Stream Only) - IBM 6400 Setup Manual

Compatibility Option 8: Automatic FF After Operator-Initiated Copy

This option determines the print position after an operator-initiated local
copy (print screen function).
OFF (the default) performs an automatic new line command after
completing a print buffer (unless a new line, form feed or carriage return
command was the last one executed). The printer is set to print at print
position 1 of the next line.
ON performs an automatic form feed command unless a form feed was
the last one executed. The printer is set to print at print position 1 of the
first line on the next form.

Compatibility Option 9: CR, EM, and NL (3287 only)

CR (Carriage Return), EM (Error Message), and NL (New Line) specify that
the printer treat the CR, EM, and NL control codes either as spaces or as
control codes.
ON (the default) treats the CR, EM and NL commands as control codes.
OFF treats the CR, EM and NL commands as spaces.

Compatibility Option 10: Bottom Margin (SCS data stream only)

Any bottom margin specified or implied by a host command will be
overridden, causing the operator panel bottom margin value to be used
OFF (the default) ignores the operator panel bottom margin value.
ON forces the bottom margin to the value specified by the operator
panel.
NOTE: If Bottom Margin is ON, the operator can enter a bottom margin;
the top margin will be forced to zero. If it is OFF, the operator panel
bottom margin is forced to zero.
Chapter 4. Configuration Menus 4–41