Chapter 2. Attaching The 4230 Printer To Your Computer - IBM 102 User Manual

Chapter 2. Attaching the 4230 Printer to Your
Computer
This chapter provides specific instructions on attaching the printer to
|
your computer. Models 102 and 1I1 can attach to a computer using
|
a twinaxial connector. Models 202 and 2I1 can attach to a
|
computer using a coaxial connector. Model 4I3 can attach to three
|
computers simultaneously using the parallel, serial, and twinaxial
|
connectors. Model 5I3 can attach to three computers simultaneously
|
using the parallel, serial, and coaxial connectors. For Models 4I3
|
and 5I3, you may want to attach the printer to more than one
|
computer. If so, you need to perform the steps in each appropriate
|
section.
|
For Coaxial or Twinaxial, look at the bezel at the rear of the printer.
If your printer has a feature card number or card name of:
Models 102, 1I1, and 4I3 Twinaxial, go to "Models 102, 1I1, and
4I3 Twinaxial Attachment" on page 2-2.
Models 202, 2I1, and 5I3 Coaxial, go to "Models 202, 2I1, and
5I3 Coaxial Attachment" on page 2-17.
For Models 4I3 and 5I3 (when parallel or serial is the active
interface), go to "Models 4I3 and 5I3 (when parallel or serial is the
active interface)" on page 2-20.
Copyright IBM Corp. 1991, 1994
2-1