Removing The Continuous Forms Device (F1) - IBM 102 User Manual

Removing the Continuous Forms Device (F1)

Note: If you are removing this forms device to install a different
forms device, make sure you change the selected forms device in
the Configuration Menu.
To remove the F1 forms device, follow these steps:
1. If forms are in the printer, unload them (see "Unloading Forms"
on page 1-51); then continue with Step 2 of this procedure.
2. Turn the power Off (O).
3. Open the access cover. Then open the front paper door as
follows:
a. Pull the door up until it will not go any higher.
b. Push the door back slightly to lock it in the open position.
P a p e r D o o r
A c c e s s C o v e r
Chapter 1. Setting Up the 4230 Printer
1-53