Cut Sheet Forms - F4 - IBM 102 User Manual

Cut Sheet Forms — F4
All paper used in the Auto Sheet Feeder should be new and without
packaging damage. The papers defined below are considered
acceptable for use in the F4 device. Any others should be
operationally tested before regular use.
Dimensions
The paper sizes shown in the following table include both single-part
and multiple-part cut sheets. Note that the term Length applies to
the paper dimension parallel to the paper motion.
Bin Number Length and Width
Bin 1 Length:
Width:
Bin 2 Length:
Width:
Bin 3 Length:
Width:
Bin 4 Length:
Width:
Thickness
Single sheet paper thickness should be a minimum of 0.086 mm
(0.0034 in.) and a maximum of 0.177 mm (0.0046 in.).
C-4
User's Guide
127 - 355.6 mm
(5 - 14 in.)
101.6 - 355.6 mm
(4 - 14 in.)
203.2 - 355.6 mm
(8 - 14 in.)
101.6 - 355.6 mm
(4 - 14 in.)
279.4 - 355.6 mm
(11 - 14 in.)
101.6 - 355.6 mm
(4 - 14 in.)
127 - 355.6 mm
(5 - 14 in.)
101.6 - 355.6 mm
(4 - 14 in.)
Capacity
80 g/m
(220 sheets)
80 g/m
(220 sheets)
80 g/m
(220 sheets)
1