Adjusting The Load Position; Adjusting The Print Alignment - IBM 102 User Manual

Adjusting the Load Position

The load position can only be adjusted following an operator initiated
load or eject (F2 forms device only) function from the operator panel.
You can adjust the load position using the Micro , Micro , or Line
Feed keys. The limits for the position adjustment from the default
position are +38 and −30.5 mm (+1.5 and −1.2 in.). If you plan to
use the Document on Demand feature (F2), see "Adjusting the
Tear-off Position" on page 1-79.
Note: Press Set Top of Form to keep the load position consistent
with the top of form position. Pressing Set Top of Form establishes
the first print line at which printing is to start on each form. The
alarm beeps and the printer displays
TOP OF FORM SET

Adjusting the Print Alignment

You can adjust dot registration and print quality for characters
created using bidirectional printing. The bidirectional alignment may
need periodic adjustment to maintain print quality.
To change the bidirectional alignment, follow these steps:
1. If the printer is ready, press Stop.
The printer displays
NOT READY
2. Press Test.
The printer displays
OPERATOR PRINT TESTS
Printer Demonstration
<A>
Chapter 1. Setting Up the 4230 Printer
1-81