Using The Printer Verification Test For The F2 Forms Device - IBM 102 User Manual

Using the Printer Verification Test for the F2 Forms
Device
To run the printer verification test, follow these steps:
1. Turn the power On (|) if not already on.
2. Wait until the printer displays
READY
3. Press Stop.
The printer displays
NOT READY
and then on Models 102, 1I1, and 4I3 you may see
15 COMMUNICATIONS CHECK
CHECK CABLE
or on Models 202, 2I1, and 5I3 you may see
28 COMMUNICATIONS CHECK
CALL SYSTEM OPERATOR
While on Models 4I3 and 5I3 (when parallel or serial is the
active interface) you may see
29 LINK ERROR
Ignore these messages until you have attached the printer to
your computer. (Press Stop to turn off the alarm, if necessary.)
4. Press Test.
<A>
<A>
Chapter 1. Setting Up the 4230 Printer
1-65