Operator Panel Removal
1. Remove the top cover.
2. Disconnect the operator panel cable.
3. Remove the operator panel mounting screws from the inside of
the top cover.
INA or Hard Disk Removal
1. Open the top cover.
2. Open the right cover.
3. Remove mounting screws as required.
4. Pop the card off the plastic standoffs.
Host Attachment Card / IPDS Card Removal
Warning: First read "Handling ESD-Sensitive Parts" on page 55.
These procedures can be used for all 311x, but some will not have the
IPDS Card.
1. If the printer POSTs ok, print the menu printouts which
describe the customer configuration. This will allow you to
restore any settings that are lost when you replace
electronics.
MENUS
TEST MENU
PRINT MENUS
MENUS
NETWORK MENU
TEST MENU
2. Explain to the customer that if he received "code patches", they
may not be included on the new card.
Note: The host attachment card has a code patch if a " * "
appears in the code level on the first page of the Host print test.
The IPDS card has a code patch if a " * " appears in the code
level on the second page. (A higher level of code without a " * "
probably incorporates the code patch.)
3. Disconnect the host attachment cable (Twinax or Coax) from the
Host Attachment Card. Remove all external trays.
82
Service Manual
1
PRINT MENUS
READY