Intercharacter Delay; Beep On Ascii Bel - Datalogic QuickScan QBT24 series Product Reference Manual

RS-232/USB-Com Interfaces

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
See page 241 for more information.
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL> character is detected
on the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other
important event.
$CR2BB00(CR)
Beep On ASCII BEL = Disable
Product Reference Guide
ning.
DEFAULT
$CR2IC00(CR)
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
acter(s). End by scanning the ENTER/EXIT bar code again.
~
00 = No Intercharacter Delay
$CR2BB01(CR)
Enter/Exit Programming Mode
representing your desired char-
CANCEL
DEFAULT
Beep On ASCII BEL = Enable
33