Rf Features; Automatic Configuration Update; Rf Address Stamping - Datalogic QuickScan QBT24 series Product Reference Manual

References

RF Features

Automatic Configuration Update

When this feature is enabled, the base station and reader will keep their configurations syn-
chronized. If a reader's configuration is altered by reading programming labels, this change is
automatically transferred and updated in a linked base station. Likewise, if the base station's
configuration is changed using Aladdin or by host commands, then the reader's configuration
will automatically be updated if this feature is enabled.

RF Address Stamping

Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
This feature only applies if
enabled.
Follow these instructions to select the delimiter character:
1. Determine the desired character, then find its hexadecimal equivalent on the
on the inside back cover. A setting of 00 specifies no delimiter character.
2. Go to page 222
gramming Mode.
3. Scan the bar code: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4. Scan the appropriate two digits from the keypad in
hexadecimal characters which were determined in the steps above. You will hear a two-
beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
Table 45. Source Radio Address Delimiter Character Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
262
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Pro-
EXAMPLES
No delimiter
character
'0' and '0'
"Source Radio Address Transmission"
Appendix D,
, (comma)
'2' and 'C'
QuickScan™ I QD24XX/QBT24XX/QM24XX
on page 221 is
ASCII Chart
Keypad, that represent the
- (dash) / (slash)
'2' and 'D' '2' AND 'F'