Ack Nak Timeout Value; Ack Nak Retry Count - Datalogic QuickScan QBT24 series Product Reference Manual

Enter/Exit Programming Mode

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout.
See page 236 for more information on setting this feature.
$CR2AT
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and
a selection of 255 specifies unlimited retries. See
$CR2AR
Select ACK NAK Retry Count Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
36
01 ACK NAK Timeout value is 200ms
DEFAULT
DEFAULT
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
acter(s). End by scanning the ENTER/EXIT bar code again.
~
page 237 for more information.
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
acter(s). End by scanning the ENTER/EXIT bar code again.
~
003 = 3 Retries
QuickScan™ I QD24XX/QBT24XX/QM24XX
representing your desired char-
CANCEL
representing your desired char-
CANCEL