Datalogic QuickScan QBT24 series Product Reference Manual page 246

References
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout.
To set this value:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 200 (setting is in 200ms increments). Pad the result with
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3. Go to page 36
ming Mode.
4. Scan the bar code: SELECT ACK NAK TIMEOUT VALUE SETTING.
5. Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 28. ACK NAK Timeout Value Setting Examples
STEP ACTION
1 Desired Setting
2 Divide by 200
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK NAK TIMEOUT VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
236
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 28
EXAMPLES
'0' and '1'
Appendix D,
for some examples of how to set this feature.
200ms 1,000ms (1 sec.) 5200ms (5.2 sec.)
01 05
'0' and '5'
QuickScan™ I QD24XX/QBT24XX/QM24XX
Keypad, that represent the
15,000ms (15 sec.)
26 75
'2' and '6' '7' and '5'