Adjusting The Delay Between The Picture And Sound - Sony DAV-F500 Operating Instructions Manual

Sony dav-f500 dvd home theatre system
Hide thumbs Also See for DAV-F500:
Table of Contents

Advertisement

Note
• Before [AUTO CALIBRATION], make sure
that the surround amplifier turns on and you
install the surround amplifier in the appropriate
location. If you install the surround amplifier in
an improper location, such as another room,
proper measurement will not be obtained.
• Avoid being in the measurement area and
making noise during the measurement (about 1
minute), to avoid measurement failure. During
the measurement, test signals are output from
the speakers.
• The environment of the room in which the
system is installed may affect measurements.
• If an error message appears, follow the message,
then select [YES].
An error message appears when:
– the headphones are connected to the surround
amplifier.
– the calibration mic is not connected.
– front speakers are not correctly connected.
– surround speakers are not correctly
connected.
– subwoofer is not connected.
– front and surround speakers are not correctly
connected.
10
Press C/c to select [YES] or [NO], then
press
x The measurement is OK.
Disconnect the calibration mic, then select
[YES]. The result is implemented.
x The measurement is not OK.
Follow the message, then select [YES] to
retry.
Note
• While the Auto Calibration function works:
– do not turn off the power.
– do not press any button.
– do not change the volume.
– do not change the function.
– do not insert or eject a disc.
– do not connect the headphones to the surround
amplifier.
– do not disconnect the calibration mic.
Tip
• You can check the distance between the listening
position and each speaker. See page 95.
98
GB
.
Adjusting the Delay
Between the Picture and
Sound
(A/V SYNC)
* Except for North American models
When the sound does not match the pictures on
the TV screen, you can adjust the delay between
the picture and sound.
X/x/c,
1
Press SYSTEM MENU.
2
Press X/x repeatedly until "A/V SYNC"
appears in the front panel display, then
or c.
press
3
Press X/x to select a setting.
• "LONG": adjusts the difference between
picture and sound by 130 msec.
• "SHORT": adjusts the difference between
picture and sound by 70 msec.
• "OFF": does not adjust.
4
Press
.
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
Note
• Depending on the input stream, "A/V SYNC" may
not be effective.
*
*
.
SYSTEM
MENU

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents