Sony DAV-F500 Operating Instructions Manual page 34

Connector panel of
the control unit
C 2
M - A
E C
Calibration mic
10
Press C/c to select [YES].
Note
• Make sure that the headphones are not
connected to the surround amplifier. You cannot
operate following Steps with the headphones
connected.
11
Press .
[AUTO CALIBRATION] starts.
Be quiet during the measurement.
Note
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• Before [AUTO CALIBRATION], install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
34
GB
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
12
Unplug the calibration mic and press C/
c to select [YES].
Note
• The environment of the room in which the
system is installed may affect measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
13
Press .
"QUICK SETUP is complete." appears on
the TV screen, and the Quick Setup is
finished.
All connections and setup operations are
complete.
To quit the Quick Setup
Press DISPLAY in any Step.
Tip
• If you change the position of the speakers, reset the
speaker settings. See "Calibrating the Appropriate
Settings Automatically" (page 97).
• If you want to change any of the settings, see "Using
the Setup Display" (page 89).
To recall the Quick Setup display
1
Press FUNCTION repeatedly until
"DVD" appears in the front panel
display.
2
Press DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press X/x to select
then press .
The options for [SETUP] appear.
94( 99)
1( 1)
T 0: 01: 08
CUSTOM
CUSTOM
QUICK
[SETUP],
DVD VIDEO