Sony DAV-F500 Operating Instructions Manual page 96

[L/R] 3.00 m/10 ft
distance.
1)
0.00 to 7.01 meters for North American models.
2)
When you perform the Quick Setup (page 33), the
default settings are changed.
3)
3.04 m/10 ft for North American models.
4)
This item appears when you set [SURROUND] to
[YES] in the [CONNECTION] setting.
Note
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
• When the speaker distance setting is not in the
recommended range,
being the number).
recommended distance.
x [LEVEL (FRONT)]
You can adjust the sound level of the front
speakers, center speaker, and subwoofer. You
can set the parameters from –6.0 dB to +6.0 dB.
Be sure to set [TEST TONE] to [ON] for easy
adjustment.
[L/R] 0.0 dB: Set the front speaker level.
[CENTER] 0.0 dB
level.
[SUBWOOFER] 0.0 dB: Set the subwoofer
level.
* This item appears when you set [CENTER] to
[YES] in the [CONNECTION] setting.
x [LEVEL (SURROUND)]
You can adjust the sound level of the surround
speakers. You can set the parameter from –6.0
dB to +6.0 dB. Be sure to set [TEST TONE] to
[ON] for easy adjustment.
[L/R] 0.0 dB : Set the surround speaker level.
*
* This item appears when you set [SURROUND] to
[YES] in the [CONNECTION] setting.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF]: The test tone is not emitted from the
speakers.
[ON]: The test tone is emitted from each speaker
in sequence while adjusting level. When you
96
GB
2)3)4)
: Set the surround speaker
/ ** m is displayed (**
indicates over the
indicates below.
: Set the center speaker
*
select one of the [SPEAKER SETUP] items, the
test tone is emitted from each speaker in
sequence.
Adjust the sound level as follows.
1
Set the [TEST TONE] to [ON].
2
Press C/X/x/c repeatedly to select the
desired speaker and the level.
3
Press .
4
Repeat Steps 1 to 3.
5
Press C/X/x/c repeatedly to set [TEST
TONE] to [OFF] after adjusting the
speaker level.
Note
• The test tone signals are not output from the HDMI
OUT jack.
Tip
• To adjust the volume of all the speakers at one time,
press VOLUME +/–.
• To return to the default setting when changing a
setting, select the item, then press CLEAR. Note that
only the [CONNECTION] setting does not return to
the default setting.