Connecting The Other Components - Sony DAV-F500 Operating Instructions Manual

To change the color system (PAL or NTSC) (Except for North American,
Latin American and CIS models)
Depending on the TV to be connected, you may be required to select either PAL or NTSC for the color
system.
The initial setting of the system for Australian and Middle Eastern models is PAL.
The initial setting of the system for Asian models is NTSC.
1
Turn off the system by pressing \/1.
2
Turn on the system by pressing \/1 while pressing VOL – on the front panel.
Each time you perform this operation, the color system toggles between PAL and NTSC.
"NTSC" lights up in the front panel display when the color system is set to NTSC.

4 Connecting the other components

You can enjoy the connected component using the six speakers of the system.
• Digital satellite receiver, etc.: A
• DIGITAL MEDIA PORT adapter: B
Digital optical cord (not supplied)
Digital coaxial cord (not supplied)
L IN
D IG IT A
L
O P TI C A
B LE
S AT /C A
L IN
D IG IT A
L
C O A X IA
B LE
S AT /C A
To the digital coaxial output jack of
the digital satellite receiver
To the digital optical output jack of
the digital satellite receiver
Note
• Connect the DIGITAL MEDIA PORT adapter so that the V marks are aligned. When disconnecting, pull out while
pressing both sides of the connector B.
To connect the DIGITAL MEDIA PORT adapter
Connect a DIGITAL MEDIA PORT adapter (not supplied) to the DMPORT jack. For details, see
"Using the DIGITAL MEDIA PORT Adapter" (page 81).
O R T
D M P
D C 5 V
M a x
0 .7 A
DIGITAL MEDIA PORT adapter
Connector panel of the control unit
23
GB