Step 6: Changing The Sound Source - Sony DAV-F500 Operating Instructions Manual

6
Press X/x to select [PROGRESSIVE
(COMPONENT OUT)], then press
7
Press X/x to select the desired setting,
then press .
• [OFF]: The system does not output
progressive signals. Select this setting
when:
– your TV does not accept progressive
signals, or,
– your TV is connected to jacks other
than the VIDEO OUT
(COMPONENT) jacks.
• [ON]: The system outputs progressive
signals. Select this setting when:
– your TV accepts progressive signals,
and,
– the TV is connected to the VIDEO
OUT (COMPONENT) jacks.
When you select [ON], the confirmation
display appears. Follow the Steps below.
8
Press C/c to select [START], then
press .
The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.
9
Press C/c to select [YES], then press
.
The system outputs the progressive signal.
When you select [NO], the system does not
output the progressive signal.
36
GB
Step 6: Changing the
.
Sound Source
You can enjoy DVD, TV, or VCR sound, etc. by
changing the sound source.
Press FUNCTION repeatedly until the
desired function appears in the front panel
display.
Each time you press FUNCTION, the function
changes as follows.
"DVD" t "FM" t "USB" t "TV" t
"SAT/CABLE" t "DMPORT" t ...
Function
"DVD"
"FM"
"USB"
"TV"
"SAT/CABLE"
"DMPORT"
Note
• When you use both the TV (AUDIO IN) jacks
(analog connection) and TV (DIGITAL IN
OPTICAL) jack (digital connection) at the same time,
the digital connection takes priority.
FUNCTION
Source
Disc that is played by the system
FM radio (page 63)
USB device (page 69)
TV
Component that is connected to
the SAT/CABLE jacks on the
control unit
DIGITAL MEDIA PORT
adapter (page 81)