Table of Contents
Advertisement
4. Maintenance
2. Lock the brake pedals together.
3. Open the bleeding nipples.
It is recommended to use hoses from the bleeding nipples to a suitable
container.
NOTE: Do not let the oil run on the ground.
4. Pump the pedals slowly until there are no air bubbles in the oil.
5. Close the bleeding nipples.
6. Check that the pedal free travel is the same on both wheels.
Check the free travel while driving with the pedals latched together.
7. Check the free travel on the rear brake pedal.
The reverse drive system is extra equipment.
4.7.6.5
Bleeding the front axle brake system
The front axle equipped with a brake system is extra equipment.
The brake system uses the same oil as the transmission system. The oil in the
brake circuits is not changed when changing the transmission oil. Therefore, the
brake circuit oil has to be changed by bleeding after every transmission oil
change. Also when repairing, the system has to be filled and bled in the same
way.
1. Start the tractor and let it run for about three minutes.
This ensures that the oil from the pump is completely free from air.
2. Make sure that the bleeding valves for the rear brakes and hydraulic trailer
brakes are closed.
3. Lock the brake pedals together.
4. Open the bleeding nipples.
There is one bleeding nipple on both sides.
GUID-92EF53D6-6FA3-438F-A7D1-490CE65AC965
1. Bleeding nipple
5. Put a hose from both bleeding nipples to containers.
1
- 370 -
Advertisement
Table of Contents
