Table of Contents
Advertisement
3.8.20.2
Engaging and disengaging the four-wheel drive
You can control the engagement of the four-wheel drive (4WD) with the 4WD
switch. The switch has three positions: ON, AUTO and OFF.
Keep the 4WD disengaged while driving on the road if it is not required. Using the
4WD is not allowed at driving speeds of over 15 km/h if road conditions are good.
GUID-CE01E060-116D-4F1C-BD9C-DB4CEE7CB507
1. 4WD switch
•
To engage the 4WD, press down the symbol side of the 4WD switch (ON).
The switch light is lit green.
•
To use the automatic function of the 4WD, turn the 4WD switch to the middle
position (AUTO).
•
To disengage the 4WD, press down the side of the 4WD switch opposite to
the symbol (OFF).
3.8.21
Driving start automatics
3.8.21.1
Driving start automatics
Driving start automatics can be used to prevent the rear wheels from slipping
while starting to drive or when changing the driving direction with the power
shuttle. The driving start automatics engage the four-wheel drive automatically,
regardless of the level of wheel slip.
If the clutch pedal has been pressed while starting to drive or when changing the
driving direction, the four-wheel drive remains engaged until the clutch pedal is
fully released.
If the clutch pedal has been pressed while driving, the driving start automatics
engages when releasing the clutch pedal.
NOTE: Driving start automatics operates only when the driving speed is under 10
km/h.
The driving start automatics is controlled from the tractor terminal by activating
and deactivating the function or setting the time that the four-wheel drive remains
engaged.
1
- 127 -
ECO
3. Operation
Advertisement
Table of Contents
