Applying Power - Luxul XAP-1030 User Manual

User Guide
The XAP-1030 is POE ready and supports Legacy (48v 1a), 802.3af, and 802.3at
POE injectors. A POE injector is included with the device. To apply power, simply
connect the opposite end of the Ethernet cable to which the access point is
already connected to the provided POE injector or other POE switch or injector. An
Ethernet cable length of up to 300 feet can be used. DO NOT yet apply power to
the POE injector or switch.
NOTE: To ensure FCC compliance and minimize high frequency noise, a
Ferrite Noise Suppresser is included with the POE injector kit. It
should be placed on the Ethernet cable at or near the connector
on the end of the Ethernet cable that plugs into the POE device.
To install it, simply unsnap the plastic fasteners, place it on the
Ethernet cable as demonstrated below and re-snap the plastic
fasteners to secure it in place.
4.4.6 Connecting to the Internet Source
This Luxul device is not a router and in most installations will be connected to a
Router or Switch in order to deliver Internet access. To do so, connect the POE
injector (or switch) to the desired Internet source using another Ethernet cable. Be
sure the source device is powered off.
Ferrite Noise
Suppresser
Poe
Device
Data
Source
The POE Injector Sends Power and Signal Over One Ethernet Cable

4.4.7 Applying Power

Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450 a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450
POE
Injector
Data/Pwr
Out
Data
In
Power Power
In Source
13 13 13