Disassembly Procedure; Paper Feed Tray Removal - Epson GT-1200 Service Manual

ADF

4.2 DISASSEMBLY PROCEDURE

Disassembly/Removal procedures for the major units in the ADF are
described in the following sections.

4.2.1 Paper Feed Tray Removal

1. Remove the ADF unit from the scanner body.
2. Move the edge guides (blue) to the center.
3. Remove 2 screws and remove the paper feed tray along with the
extension tray.
4. Turn the tray over and disconnect the connector cable for the paper
size sensor from the relay connector.
Screws
Figure 4-1. Paper Feed Tray Removal
Rev. A
Paper Feed Tray
Disconnect this connector.
(For paper size sensor)
Figure 4-2. Connector Removal
Disassembly and Assembly
Paper Feed Tray
(Reverse Side)
4-2