Table of Contents
Advertisement
EPSON Perfection4180 Photo
4.2 Disassembly Procedure
This section illustrates how to remove the main components of this product. Unless otherwise specified, the reassembly procedure is omitted here since the product can be reassembled
in the reverse order of the disassembly procedure. For the engagement of the main components, refer to the general exploded views in the Appendix.
The following flowchart shows the disassembling procedure step-by-step. When disassembling any unit, refer to the corresponding page number shown in the following figure.
Start
Removal of TPU Unit
(P.33)
Removal of Housing Upper
(P.34)
Removal of Carriage Unit
(P.35)
Removal of Panel Board
(P.38)
Removal of Driven Pulley, Driven Pulley
Spring and Driven Pulley Holder Assy (P.45)
DISASSEMBLY/ASSEMBLY
Removal of TPU Inverter
Board (P.48)
Removal of Power Switch
Removal of Main Board
(P.39)
Removal of Panel FFC
Removal of CR Motor Unit, Motor Tension Belt
(P.43)
Figure 4-2. Disassembly/Assembly Flowchart
Disassembly Procedure
Removal of Hinges
(P.51)
(P.41)
and CR Tension Belt (P.46)
Revision A
32
Advertisement
Table of Contents
