Control Board Unit Removal - Epson GT-1200 Service Manual

ADF

4.2.2 Control Board Unit Removal

1. Turn the ADF over and remove 3 screws, then remove the shield cover.
2. Disconnect all connector cables from the connectors on the control
board. (See Figure 4-4 for connector location indicated with the yellow
broken lines.)
3. Remove 2 screws and remove the control board unit.
Screws (with toothed washers)
Figure 4-3. Shield Cover Removal
Rev. A
Shield Cover
ü ü ü ü
When installing the control board unit, make
CHECK POINT
sure that the bottom edge of the board properly
fits in the edge holder.
Screws
Figure 4-4. Control Board Unit Removal
Disassembly and Assembly
Control Board Unit
Remove the board
from the edge holder.
4-3