Epson GT-1200 Service Manual page 51

GT-12000
4. Disconnect the connector cable for the lamp from the connector CN2
on the inverter board assembly. Then remove the lamp from the
carriage.
5. Disconnect the cable (black) from the connector CN1 on the inverter
board assembly. Then remove the bracket (silver) fixing the ferrite core.
6. Remove 2 screws (No.6) securing the inverter board assembly.
7. Slide the inverter board assembly toward the front side of the scanner
to release the engagement with the hook on the carriage. Then remove
the inverter board.
ü ü ü ü
When assembling, make sure that the cover is
CHECK POINT
securely engaged with the hook on the carriage.
H o o k
R e a r
Rev. A
C o v e r
F r o n t
C a r r i a g e B a s e
Lift up to remove.
CN2
CN1
Figure 4-19.
Lamp Assembly and Inverter Board Assembly Removal
Disassembly and Assembly
Cut Part
of the Board
Screws (No.6)
4-15