Operation In Automatic Mode - ProLights NEWMOON User Manual

3.3 Operation in automatic mode

If no DMX control signal is present at the jack DMX INPUT, and the unit independently runs through its show
programme.
• To set the automatic mode is necessary to position the DIP-switches [9] and [10] to "OFF".
• Through the DIP-switch [5 - 8] can be selected in descending order, the execution speed.
• To select, however, the pre-set program "Program" [1 - 15] to proceed alog the following settings:
The program "Program" [1 - 15] as a binary number is set using DIP-switch [1 - 4]. Then, it is by adding the
values of the DIP-switches in the ON position.
Examples of programs "Program" [7], Program [10], Program [14]
Value
Value
Value
It can select the speed of execution of pre-set programs, in ascending order, using the DIP-switch from [5]
to [8].
NOTE. in automatic mode the NEWMOON is set as the master unit (MASTER), while the other will be set as
slave units (SLAVE)
NEWMOON
DIP Switch DIP Switch
[1] [2]
Value = 1 Value = 2
DIP Switch DIP Switch
[3] [4]
Value = 4 Value = 8
Fig.5 Program "Program" [7]: switch [1 - 3] to ON.
Fig.6 Program Auto [10]: switch [2] e [4] to ON.
Fig.7 Program Auto [13]: switch [1], [3] e [4] to ON.
7